Looking for a review on Blackhawk B6350 floor jack? Well, this article will unbox this best Blackhawk B6350 fast lift service jack so that you can easily decide whether you should go for it or not.
Let’s get started.
|3.5 ton (7,000 lb)|
|5.5" (14 cm)|
|22" (55.9 cm)|
|Weight||85 lb (38.6 kg)|
L x W x H
|28.5 x 13.75 x 6.5|
Blackhawk B6350 Fast Lift Service Floor Jack Review Key Features
Now that you know about the Blackhawk B6350 floor jack’s key features from the table above, you will read enough about these features below so that you get sufficient knowledge of them, their benefits, and more in the following sections.
The first and important feature of the Blackhawk B6350 jack is its lifting power. This aspect shows how much load you can raise with this model. It’s essential to check out this factor in any floor jack before you opt for it.
Many newbie floor jack buyers opt for a jack that has a lower load capacity than the weight of the vehicle they want to lift it with. This triggers another question: what’s your car weight? First, you should know about your car weight then look for a jack of that capacity.
This Blackhawk B6350 service jack can lift most trucks, SUVs, and cars. That’s because this model features a 3.5 ton (7,000 lb) load capacity. This implies that you can lift up to 7,000 lb (3175 kg) load with this model, which includes most heavy-duty trucks as well, let alone lightweight pickups and small cars.
Minimum Lift Height
Does your vehicle’s weight fall in the load capacity of Blackhawk B6350? If so, the jack’s minimum height is more important than its load capacity. It will definitely lift your car. But what if you cannot slide it under your car, which might be low to the ground?
You’ve guessed it. You should check out the ground clearance of your truck, SUV, or any car you want this jack for. That’s because this floor jack cannot be installed under low-profile vehicles.
But here’s the thing. This might be fit for your low-profile car if its ground clearance is more than 5.5 inches (14 cm). The floor jack features a 5.5 inches min-height, which implies that you can slide it under 14 cm or more ride height.
Maximum Lift Height of Blackhawk B6350 Service Floor Jack
How much space do you want under your vehicle so you can easily do the repair or maintenance? You won’t need that much space when you just do a tire change. But that won’t be a problem in most cases.
You will need to change oil, brake pads, or do other mechanical work where you will need more space than for the former cases. Sometimes you will need to get under your car as well. Disclaimer! Don’t get under your car relying on a jack only, use a jack stand as well.
The more and less area under your car when you lift it with a jack depends on the maximum lift height of a jack. And this Blackhawk B6350 has brought a 22 inches (55.9 cm) space under your car when you pump it to its max height. It’s more than enough space for doing any mechanic work under your vehicle.
If you got a lifted truck or other raised vehicle, you should check its ground clearance as well, not because of whether you can install the jack under it. But because to check if this floor jack will be able to touch the jack point or not when you extend it to its max height – 22 inches.
Many lifted trucks have ground clearances of more than 22 inches. And in that case, this Blackhawk B6350 will be of no use even if you extend it to its max height. It won’t even touch the jack point.
Also, since you won’t be working without a jack stand, right? Its height should be less than the max height of this Blackhawk floor jack. If that’s more than 22 inches, you won’t be able to place it under your car either. Because it won’t make enough space for the stand to be installed.
The Blackhawk claims that the B6350 model features a fast lifting technology besides its single-piston pump. It raises the load faster. Most of the rapid-rising floor jacks have a dual-piston pump that enables them to lift a weight with just a few strokes.
The B6350 model has a single yet fast lifting pump. A single-piston pump lifts weight quicker than a bottle jack. But it isn’t as fast as a dual piston pump. When it comes to hydraulic jack, the Blackhawk model lifts load fast.
For safety purposes, the first thing you should do is not to lift more weight with the model than its capacity, which has been discussed earlier. The Blackhawk B6350 also features a safety valve that prevents the jack from overloading.
It also prevents you from over-pumping the jack, ensuring safe and secure operation. You will experience a precise load control in this model by the universal joint control it has. These two aspects help you safely lift your load.
The service jack has a long handle. Its lower part is foamed so it does not damage your car when you’re pumping and prevents any dent on your car. Thus ensuring your car’s safety.
Floor jacks are so heavy that it’s hard for most people to pick them up or position them under a jack point. Therefore, they feature steel casters to easily roll it over the floor and to avoid picking it up. The Blackhawk model features two front steel casters and two rear swivel casters.
The back casters ensure maximum mobility as you can move them around 360 degrees. You can replace them as well when they get broken when you overload them. Such swivel casters are also handy in positioning the jack under a jack point.
Another aid for mobility is the long handle. It’s around a 50 inches handle and comes in two pieces. The two pieces help with storage as well when you don’t have enough space to keep that long handle in.
Blackhawk B6350 Floor Jack Review on its Saddle
The saddle is the only part of floor jacks that come in contact with the body you want to lift. Say, you want to raise your car, the saddle top will touch the jack point under your car. That’s why it has importance.
The saddle should have a wide and rough surface for maximum safety and better gripping. The Blackhawk B6350 has a 4 inches (10.2 cm) wide saddle diameter, providing more surface area for a jack point. The wider the saddle, the lower will be the pressure on the jack.
The Blackhawk saddle hosts a rubber pad on its top, which has circular channels. Such a frictional full top surface gives a stronger grip on the jack point and prevents sliding. This model also has a steel construction that provides long-lasting durability.
How Does Blackhawk B6350 Jack Work?
- When you want to lift your car with this model, locate the jack point under your car.
- Place the jack under the point and start pumping.
- Since you won’t be working without a jack stand, make sure you raise your car high enough to install a jack stand.
- Once you’ve installed a stand, rotate the jack’s handle counterclockwise to lower the car. It will rest on the stand now.
- After you complete your job whether it be a tire change, oil change, or any other repair and want to remove the stand, bring back the floor jack.
- Raise the car again to a sufficient height so you can remove the stand.
- Once the stand has been removed, slowly lower the jack, and so the car will touch the ground.
Are Blackhawk floor jacks good?
Blackhawk floor jacks are accountable as the best in the market. They are high-quality products coming with top-notch parts. The potential of its jack to lift a car is remarkable, and it offers safe lifting. If you want to have a durable jack that goes down the road, Blackhawk floor jacks are a go-to option.
This was a complete Blackhawk B6350 Fast Lift Service Floor Jack Review. You’ve seen that each feature has been opened up. And now you can decide whether you should opt for this model or not. This is one of the best and highest-rated floor jacks that you can find online. Speaking of it, you can find all of its ratings, other customer reviews, and its price as well by clicking the yellow button below.